After the drying
Mold Inspection & Testing in Beaverton, OR
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is holding a panel joint closed?
A bead of sealant, and in most cases that is all. The grooved plywood sheets were butted together and the gap between them filled, so unlike a lapped siding there is nothing behind the joint to catch what gets past the surface.
How long does that bead last?
Ten to fifteen years is typical, against a wet season that runs from October through May every year. It is a material with a service life being asked to do a permanent job, so the failures are a matter of when rather than whether.
What is behind the panel when it goes?
Sheathing and framing that have been taking water quietly for a while. Because the panel itself is intact and painted, there is often nothing visible outside, and the condition is found when something is opened up for another reason entirely.
These questions come from the Beaverton page.