After the drying
Mold Inspection & Testing in Worthington, OH
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Local contractors · findings documented for your claim
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is an orphaned water heater flue?
A chimney that was sized for two appliances and now carries one. When the furnace was replaced with a sealed unit venting through the wall, the water heater was left connected to the old masonry flue, which is now several times larger than it needs to be.
Why does that put water in the chimney?
Because the gases never get warm enough to rise cleanly. A small appliance cannot heat a large flue, so the exhaust cools on the way up and the moisture in it condenses on the masonry instead of leaving at the top. That happens every time it fires.
What does the damage look like?
Staining and soft plaster on an interior wall beside the chimney, often upstairs, with nothing wrong on the roof. White salts on the brickwork are the giveaway. It is slow, it runs for years, and it is almost always blamed on flashing first.
Read it with the local conditions on the Worthington page.