After the drying
Mold Inspection & Testing in Sandusky, OH
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Where does the water stop in a house that has been added to?
Usually at the joint, and then it turns. The addition sits on its own footings and its floor framing rarely runs the same way as the original, so water crossing the line spreads along a new set of joists instead of continuing straight. The wet area maps to the structure rather than to the room layout.
What makes the addition stay wet after the older half is dry?
Because they are two buildings touching. The addition normally has shallower footings, less insulation and a colder floor, so the same water sits longer in it. Readings are taken separately on each side of the joint and the drying is set up twice, which is why one half can be signed off while the other runs on.
Does a thaw-season loss behave differently?
It does, and April is when both things happen at once here. The ground is moving as it thaws, so the joint is at its widest, and the building has not yet warmed enough to help. A loss in that window travels further through the joint and dries more slowly than the same loss in late summer.
This FAQ belongs to the Sandusky page; it is repeated here.