Skip to content
My Water Damage and Restoration Marion logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Marion, OH

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

No obligation: the assessment comes before any scope

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
An independent contractor, walking the homeowner through what he found.

Frequently asked questions

What is under the asphalt?

Brick, on most of the older streets. Rather than take the brick up, the city surfaced over it, so there are two pavements stacked: a rigid one underneath that was laid on sand, and a flexible one on top that follows whatever it does.

Why does that matter for drainage?

Because water gets in between. Once the asphalt cracks over a brick joint, water runs down into the sand bed and travels along it rather than leaving at an inlet, and it surfaces wherever the layers are worst, often at the curb line.

What does rebuilding a brick street involve?

Taking both layers out rather than patching the top, which is why it so rarely happens. A patch laid over a moving brick base fails again within a few winters, so the honest expectation on these streets is recurring surface repair.

This FAQ belongs to the Marion page; it is repeated here.

Need mold inspection & testing in Marion now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415