After the drying
Mold Inspection & Testing in Kent, OH
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is the garage door the problem here?
Because of where it sits. The garage is at basement level with the drive running down to it, so the whole paved area is falling toward one large opening at the lowest point of the building. A door is not a foundation wall, and it is taking what a foundation wall would.
What is on the other side of the garage wall?
Usually finished rooms at the same level. These plans put the garage into the basement story alongside living space, so water that gets in is on the same floor as rooms people use, separated by a stud wall rather than by a story.
What is done about the drive?
A channel across the opening connected to something that can take the flow, and keeping the fall of the drive from concentrating everything at the door. It is the only thing that changes the situation, because the levels themselves are not going to change.
These questions come from the Kent page.