After the drying
Mold Inspection & Testing in Grove City, OH
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is the damage all at the bottom of the wall?
Because the sheathing behind the siding is a flat impermeable board. Water getting past the vinyl cannot soak into it or spread across it, so it runs straight down the face and collects at the bottom plate. However high up the water got in, that is where it ends up and where the wood goes.
Does the foam itself get damaged?
No, and that is misleading. It sheds water without absorbing anything, so it comes off looking as good as the day it went on while the plate underneath has been wet for years. The condition of the sheathing says nothing at all about the condition of the wall.
How far along the wall does this go?
Usually further than the entry point suggests. Water running down a smooth board also spreads sideways along the plate once it arrives, so the wet run at the bottom is wider than anything above it. The plate is read along its length rather than at the point below the suspected entry.
Read it with the local conditions on the Grove City page.