Skip to content
My Water Damage and Restoration Troy logo
Containment poles and a negative-air machine coming off a van, the setup for removing growth without spreading it.

Contained removal

Mold Removal & Remediation in Troy, NY

Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.

Quoted on site by the contractor who visits

Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.

Often needed alongside

  • Mold Inspection & Testing

    An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A contractor at the door walking a homeowner through what comes out, what gets cleaned, and when the wall closes up.
A contractor setting expectations with the homeowner.

Frequently asked questions

What is inside the cornice?

Timber framing, clad in sheet metal. It projects out from the top of the front wall over the sidewalk, and the metal is a skin over a structure rather than the structure itself, so once water gets behind that skin it is in wood that cannot dry.

Why does it fail at the top?

Because the top is flat and the metal moves. The upper surface collects rather than shedding, and four months of freezing work the seams and the fixings every winter, so the joints open at the one part of the building nobody can see or reach easily.

Where does cornice water show inside?

Floors below, at the front of the building. Water entering at the cornice is at the top of the wall, so it runs down inside the masonry and the framing and appears at a ceiling or a window head well down the elevation. The search goes up from there.

The Troy overview carries this FAQ with the city research.

Need mold remediation in Troy now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415