After the drying
Mold Inspection & Testing in Schenectady, NY
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Local contractors · findings documented for your claim
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What are the empty shafts inside these walls?
What is left of an earlier heating system. When a house moves from one kind of heat to another the old risers are usually cut and capped rather than pulled out, and the chase they ran in stays as a void through the floors. It connects levels that otherwise have nothing between them.
How are they found?
By following the water rather than by looking. Nothing indicates them from the room, so when a wet area appears well below a failure with dry floors in between, a chase is usually the explanation, and the wall is opened where the readings lead. Older houses often have two or three of them.
What does drying one involve?
Opening it at more than one level. A closed shaft has no ventilation, so equipment in the rooms does nothing for what is inside it, and air has to be introduced into the void itself and exhausted from the other end. Readings are taken inside the chase rather than on the wall beside it.
Open the Schenectady FAQ beside the housing and climate notes.