After the drying
Mold Inspection & Testing in Port Jervis, NY
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
A stone cellar never reads properly dry. What is the finish point?
It does not reach the numbers a modern basement does, and it is not held to them. The target is a stable condition rather than a dry one: the standing water out, the earth floor surface dried, air moving, and the framing above at a proper reading. Getting there usually takes two weeks, and the rooms above finish sooner.
Can the plaster upstairs be saved?
In most cases yes. Lime plaster on wood lath is tolerant of a soaking and comes back if it is given air and not left wet for weeks. Base and casings come off so the wall bottoms can breathe, and the keys behind the lath are checked. Plaster that has lost its keys and moves under a hand is the part that goes.
The house was empty when the line split. What gets checked first?
The lowest point and the path between. Water that ran unattended has found the stud bays, and it will be standing in the cellar rather than sitting where it started. The floor structure over that cellar is read first, then the bays on the wall that carried the line, then the finishes. Appearance is the last thing consulted.
Read it with the local conditions on the Port Jervis page.