After the drying
Mold Inspection & Testing in Winston-Salem, NC
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is the vent a weak point?
It is a hole cut through a finished wall, sealed from outside with whatever the installer used. There is no flashing in most cases, the assembly moves as it heats and cools through every winter, and the fire in front of it means nobody has looked at the inside face of that wall since the day it went in.
Where does water from the vent end up?
Into the wall cavity behind the appliance and down to the floor structure. Because a sealed fire sits tight against the wall, the staining appears at the base of the wall beside it or on the floor, and the connection to the vent above is not obvious from inside the room.
Who should look at it?
A gas engineer for the appliance and its termination, and a builder for the wall. The two questions are separate and both matter: whether the flue is still sealed and working correctly, and whether the penetration is still weathertight. Neither of those is a restoration contractor's call.
The same questions, in context, on the Winston-Salem city page.