After the drying
Mold Inspection & Testing in Thomasville, NC
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How does water get inside a duct?
From the air around it. Cold supply air keeps the duct's inner liner well below the temperature of a humid crawl space, and where the insulation or the outer wrap has been compressed or torn, moisture condenses on the liner and runs down inside it. Any sag in the run becomes the place it collects.
What are the signs of it from inside the house?
Weak airflow from one or two outlets, a musty smell when the system starts, and sometimes damp around the register itself. Because the cause is under the floor and not in the room, it frequently gets treated as a cooling problem for a season or two before anyone looks in the crawl space.
Is the duct repairable or does it get replaced?
A wet flexible run is normally replaced. The liner and the insulation between it and the outer wrap hold moisture and cannot be dried in place, and the sag that caused the trouble is a fault in how it was hung. Replacing the run and supporting it properly along its length deals with both at once.
This FAQ belongs to the Thomasville page; it is repeated here.