After the drying
Mold Inspection & Testing in New Bern, NC
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why does salt water change the scope?
Because the salt stays when the water goes. It soaks into plaster, board and framing and remains there, and salt draws moisture out of the air, so a wall that has been dried to a proper reading will pick up again in humid weather and keep doing it.
Can salt be dried out of a wall?
No, only rinsed or removed. Drying takes the water and leaves the salt behind, so material below the flood line generally comes out rather than being dried in place. That is a larger scope than a freshwater loss of the same depth, and it is the honest answer.
What else should be looked at afterward?
The metal. Connectors, fasteners, ductwork and electrical terminals that have been in salt water corrode for years afterward, so what matters is not just whether the building dried but what the salt is still doing to the things holding it together.
This FAQ belongs to the New Bern page; it is repeated here.