After the drying
Mold Inspection & Testing in Jacksonville, NC
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is the wall across the old garage door the wet one?
Because it is standing where the floor drains to. The slab was laid to fall toward the door so that water would run out, and the conversion put a framed wall on that line, so the bottom plate now sits at the lowest edge of a floor that is still trying to drain there.
Was the conversion done wrong?
Usually it was done quickly rather than wrongly, and the base detail is what gets left out. Raising the plate, flashing it, or changing the fall of the slab are all things that would fix it, and none of them are visible once the room is finished.
What does the repair involve?
Opening the base of that wall along its length and dealing with what is under the plate, which is the part that was skipped. Simply drying and reboarding leaves the same detail in place, so the wall is wet again after the next heavy season.
Read it with the local conditions on the Jacksonville page.