Contained removal
Mold Removal & Remediation in Hickory, NC
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
No obligation: the assessment comes before any scope
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What makes a floor cup when nothing has leaked?
Moisture arriving from underneath. The top of each board is sealed with finish and the bottom is open to the crawl space, so when that space runs humid the underside takes up moisture and swells while the top does not. The board lifts at its edges, which is the cupping you can see and feel.
Is that a loss or a condition?
Usually a condition, and telling them apart is the first job. A floor responding to a humid crawl cups gradually and across a whole area, while a leak cups locally and quickly. Readings are taken in the crawl as well as in the floor, because the answer decides whether there is anything to find.
Does the floor flatten out again?
Often, if the crawl is brought under control before the cupping sets. Boards that have taken moisture from below will give it back and settle, but a floor that has cupped through several seasons has usually been sanded or has taken a set. Dealing with the space underneath is what stops it returning.
Open the Hickory FAQ beside the housing and climate notes.