After the drying
Mold Inspection & Testing in Garner, NC
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Local contractors · findings documented for your claim
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The boards lifted in the hall but the leak was in the kitchen. How?
Because a floated floor is one continuous sheet of planks over a film, with nothing at the doorways to stop water. It runs under the whole area and the boards lift wherever the swelling finds the least resistance. The damaged spot marks a weak point in the floor, not the location of the failure.
Can a floated floor be dried in place?
Very seldom. The underlayment film traps water between the planks and the subfloor, so there is no path for it to leave, and the planks themselves are usually a fiber core that swells and does not recover. The covering comes up along the run, the film is pulled, and the subfloor underneath is dried directly.
What is checked before a new floor goes down?
The subfloor, on consecutive days, with pins rather than a surface reading. A panel that was under a film for a week is wetter than the room suggests and releases slowly. New covering goes down only after the numbers have been flat for several days, since a floated floor over damp decking will cup again within a season.
Read it with the local conditions on the Garner page.