After the drying
Mold Inspection & Testing in Troy, MI
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Local contractors · findings documented for your claim
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why do lines split in the garage wall?
Because an attached garage is unheated but shares a wall with heated space, and a supply line run in that wall sits on the cold side of the insulation. Four months below freezing is ample. The wall is opened from the heated side, the insulation that kept the pipe cold is pulled, and the framing is read before anything goes back.
It hardly rains here. Where do the losses come from?
Almost entirely from plumbing and appliances. With under 34 inches a year and a light wettest month, weather is rarely what puts water in a house here. That changes the work: the water is clean more often than not, it starts inside the building envelope, and the drying is about how far it traveled through the framing before it was found.
The basement wall is furred tight to the block. Does that matter?
It matters a lot. Furring fixed directly to masonry leaves no gap, so water between the two cannot be reached by air moving in the room and the drywall face reads dry while the cavity is not. The finish and furring come off where the meter shows moisture, the block is dried exposed, and it is refastened only once readings hold.
Open the Troy FAQ beside the housing and climate notes.