After the drying
Mold Inspection & Testing in Traverse City, MI
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Local contractors · findings documented for your claim
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is a sand point?
A pipe with a screened tip driven down into shallow water-bearing sand, pumped from the surface. They are cheap, they work well in the right ground, and a great many were put in when these houses were built. The water they produce comes from a few feet down rather than from a deep aquifer.
How does this become a water damage question?
Through the equipment indoors. The pump and the pressure tank sit in the basement, and a point that is losing suction makes the pump cycle hard and run hot. Failures at the tank, the fittings or the pump itself discharge into the lowest room in the house, frequently while nobody is at home.
What happens when the table drops?
The point starts drawing air and the system loses pressure. In a dry late summer that is common, and the usual response is to run the pump harder, which is what damages it. Knowing that the supply depends on the shallow table explains why the problem appears in the same weeks each year.
The same questions, in context, on the Traverse City city page.