After the drying
Mold Inspection & Testing in Forest Hills, MI
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is a laundry failure worse upstairs than in a basement?
Because of what is underneath it. In a basement the water lands on a slab and stays there, where it can be extracted. On the main floor it goes into the floor structure and then into the ceiling of the room below, so there are two finished surfaces and a closed cavity between them to deal with.
What is opened after one of these?
The ceiling below, along the run the water took. The floor above can usually be dried from the top once the covering is lifted, but the cavity between the two and the back of the ceiling cannot be reached from anywhere else. Opening from underneath also lets the insulation out, where there is any.
How much water is actually involved?
Considerably more than a spill. A supply hose under constant pressure delivers continuously until somebody shuts it off, so the volume depends on how long the house was empty rather than on the size of the machine. A failure at the start of a working day is a different job from one on a Saturday morning.
Read it with the local conditions on the Forest Hills page.