After the drying
Mold Inspection & Testing in Saco, ME
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What goes through the wall behind a mini-split?
Refrigerant lines, a power cable and a condensate drain, bundled together and passed through a single cored hole. The hole is usually sealed with mastic or expanding foam and then covered with a plastic trim on the outside of the wall.
Why does it leak?
Because that seal is doing a flashing's job. Mastic has a life of a few years in weather like this, and the penetration is typically drilled level or sloping the wrong way, so water running down the wall finds it and follows the pipes in.
How should it have been done?
With the hole cored sloping down to the outside and a proper sleeve and flashing rather than a bead of sealant. That is worth specifying when a unit is fitted, and worth correcting on an existing one before the wall behind it is opened up.
Read it with the local conditions on the Saco page.