Contained removal
Mold Removal & Remediation in Bangor, ME
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
Quoted on site by the contractor who visits
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is the wall wet beside the front steps?
Because of the joint between them. The granite sits on the ground beside the foundation rather than being built into it, so there is a line between two heavy masses that were never joined, and water runs down it straight to the base of the wall.
Why does it get worse each year?
Because the freeze works at it. Water sitting in that joint freezes and expands through five cold months, which opens it a little further every winter, so a hairline that was nothing twenty years ago is now a route. The progression is slow and it is one-way.
Can the joint be sealed?
It can be filled, and it will open again unless the movement is dealt with. The more durable answer is getting water away from the top of the steps so that less arrives at the joint in the first place, since the two masses are going to keep moving regardless.
The Bangor overview carries this FAQ with the city research.