After the drying
Mold Inspection & Testing in Taunton, MA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How does soft water damage copper?
Hard water leaves a thin mineral scale inside the pipe that protects it; soft acidic water leaves nothing, so the copper is in direct contact with the water for its whole life and slowly loses metal from the inside. Eventually it perforates.
What does a failure look like?
A pinhole rather than a split, releasing a fine spray or a slow weep rather than a flood. That is why these run for so long before they are found: there is no noise and no rush of water, just a patch of ceiling that gradually darkens.
Does replacing the failed section help?
Only that section. The whole system has been drinking the same water for the same number of years, so a first pinhole is usually a signal about the age of the plumbing generally, and planning around that beats replacing a foot at a time.
This FAQ belongs to the Taunton page; it is repeated here.