After the drying
Mold Inspection & Testing in Baton Rouge, LA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How long will equipment run for a July loss in a slab house here?
Plan on a week to ten days, longer if the slab held water under a floor for a while. Baton Rouge summers are humid enough that the space has to stay sealed and the dehumidifiers do the work, and concrete gives its water up slowly. The contractor reads the slab and the drywall daily and pulls the equipment on the numbers.
Can the carpet be saved if the pad comes out?
Sometimes, when the water was clean and it is lifted within a day. The pad underneath is never saved; it holds water like a sponge and does not dry in this humidity. The contractor lifts the carpet, discards the pad, dries the slab to a reading, and relays the carpet if it has not delaminated or been touched by contaminated water.
The drywall looks fine but the contractor wants to cut it. Why?
Because the back of the sheet is what got wet. Water on a slab wicks up drywall from the floor, and behind brick veneer it also collects along the bottom plate where nothing reads it from outside. The contractor cuts at a standard height, dries the framing and the plate, and the new sheet goes on only after the cavity reads dry.
Read it with the local conditions on the Baton Rouge page.