Skip to content
My Water Damage and Restoration Evansville logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Evansville, IN

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

Quoted on site by the contractor who visits

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
A contractor setting expectations with the homeowner.

Frequently asked questions

Why does heavy rain put water in the basement through a drain?

Because the system carries both. Drainage and storm water share one pipe here, so a heavy rain fills it, and when it is full it has to go somewhere; the lowest openings connected to it are basement fixtures and floor drains, so it comes back up through those.

What is a backwater valve?

A one-way valve fitted on the house drain that lets what the household puts down it go out and stops anything coming back. Where one is fitted and working these events are a non-event; where there is none, the basement is the relief point for the street.

Is it worth fitting one afterward?

It comes up on almost every one of these, and the answer is usually yes. It is a modest piece of work against an event that will recur every time the system is overloaded, and the household has just seen exactly what that looks like.

Read it with the local conditions on the Evansville page.

Need mold inspection & testing in Evansville now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415