After the drying
Mold Inspection & Testing in Skokie, IL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What is an interior drain tile system?
A channel cut around the inside edge of the basement floor, with perforated pipe in it running to a sump. It collects water that has already reached the wall and carries it to the pump, rather than stopping it outside the way an exterior system would.
Does that mean the wall stays wet?
It does, and that is the design rather than a fault. The system accepts that water will come through and manages where it goes, so a block wall above the channel can read damp permanently without anything having gone wrong.
What does that change in a loss?
What can be put back. Finishing tight against a wall that is wet by design traps it, so the work here has to allow the wall to keep doing what the system expects, which rules out some finishes that would be fine elsewhere.
This FAQ belongs to the Skokie page; it is repeated here.