After the drying
Mold Inspection & Testing in Rockford, IL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why would adding insulation cause a problem?
Because of where it ends up. In a low-pitch roof there is very little room at the eaves, so blown material runs out to the edge and covers the openings the attic was meant to breathe through. The insulation does its job and the ventilation stops, and nothing about that is visible from below.
What builds up in an attic that cannot breathe?
Moisture, steadily, through the whole winter. Air from the house carries it up into the attic through every gap, and with no ventilation it has nowhere to go, so it condenses on the sheathing and the underside of the roof through five cold months. The space is damp before any loss happens.
Is the insulation taken back out?
Pulled back from the edges rather than removed. The aim is to clear the openings at the eaves and keep the material where it is doing good, which usually means baffles at the edge and a clear path above them. It is done while the attic is open for the drying.
This FAQ belongs to the Rockford page; it is repeated here.