Skip to content
My Water Damage and Restoration Lincolnwood logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Lincolnwood, IL

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

No obligation: the assessment comes before any scope

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
An independent contractor, walking the homeowner through what he found.

Frequently asked questions

Why is a built-in planter a problem?

Because it keeps wet soil against the wall on purpose. The box is built as part of the masonry, usually with no gap and no drainage, so the earth in it is in direct contact with the same brick that forms the front of the house. Every watering and every rainfall puts moisture straight into that wall.

What shows up inside?

Damp at the bottom of the front wall and around the window above the planter, usually in the room behind it. Because the source is outside and at the same height as the interior floor, it is frequently mistaken for a window leak, and the window gets replaced while the planter carries on doing it.

Can the planter be kept?

Only with work. Lining it, adding a drainage outlet and separating the soil from the shared wall will stop most of it. The simpler answer many owners take is to empty it and use pots inside the box instead, which keeps the appearance of the front elevation without keeping wet ground against brick.

These questions come from the Lincolnwood page.

Need mold inspection & testing in Lincolnwood now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415