After the drying
Mold Inspection & Testing in Des Plaines, IL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How much water does a washer actually put out?
More than people expect, and fast. A machine discharges its drum through the standpipe in a short burst, so a pipe that will not take that rate overflows at the floor every cycle. It is a small volume each time and a large one over a load, and it lands on the lowest slab in the building.
Does it matter what kind of water this is?
It does. Discharge from a washing machine is not clean supply, so porous material it reaches is removed rather than dried back, and the slab is cleaned before it is read. The structure is generally fine; it is the stored contents and any finish at floor level that go.
Why is the same corner wet again?
Because the blockage was the cause and the drying was the symptom. A standpipe that has backed up once will do it again on the next load unless the line itself is cleared, so these arrive as a repeat rather than as an event. The history of the corner is usually more informative than the current reading.
Open the Des Plaines FAQ beside the housing and climate notes.