Skip to content
My Water Damage and Restoration Decatur logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Decatur, IL

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

Independent local crews · scoped at the property

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
The assessment happens on site, not over the phone.

Frequently asked questions

Why is the wall wet again after it was dried?

Because the block is hollow and the cells behind the face were never dry. Water sits inside them below the floor line, out of reach of any air moved across the surface, and feeds back through the block for days. A wall that dries and returns is the normal signature of this, not a sign the first attempt failed.

What does draining the cores involve?

Small holes drilled through the face into each cell at the bottom course, so the water has somewhere to go other than back into the wall. It is a decision made in the first day or two, because a wall left to release on its own can hold a job open for weeks, and the holes are closed up at rebuild.

Does a spring loss run longer than a winter one?

It usually does. The heaviest rain lands in a mild spring, when the ground around the wall is already carrying water and the house has not yet had a dry warm stretch, so the cores refill from outside about as fast as they drain inside. The same loss in a cold, dry month gives up its water noticeably faster.

This FAQ belongs to the Decatur page; it is repeated here.

Need mold inspection & testing in Decatur now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415