After the drying
Mold Inspection & Testing in Kaneohe, HI
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Local contractors · findings documented for your claim
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is the underside of the house being tented?
Because there is no enclosure to work with otherwise. A floor over open posts and piers sits in whatever air is passing under it, and here that air is humid all year. Sheeting the space turns it into a chamber that can actually be dried. Without it the equipment is conditioning the outdoors and the readings barely move.
How long does a floor take to dry over ground like this?
Ten days to a fortnight, and the ground below is why. The decking and joists are being supplied with moisture from underneath the whole time, so the run is longer than the water from the loss alone would suggest. Readings are taken with pins in the joists and repeated for several days before anything is closed.
Single-wall construction has no cavity. Does that make it easier?
In one way, yes: there is nothing hidden to open and nothing to hold water out of sight. What it takes away is the option of drying a wall through an opening, because the board is the wall. Everything happens at the surface, and material that has swollen or delaminated is replaced rather than dried, since there is no substrate behind it.
Read it with the local conditions on the Kaneohe page.