After the drying
Mold Inspection & Testing in Honolulu, HI
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How is a single-wall house dried after water on the floor?
On the boards themselves. There is no cavity, no insulation and no drywall in a single-wall house, so the water is in the planks and the floor. The contractor seals the room, runs air across both faces of the wall where it can, dehumidifies, and reads the boards daily. The wood dries in place; the finish is redone only when the readings hold.
Will opening the house to the trade winds dry it out?
Not reliably. The trade winds move air, but the air they bring is humid in every month, so a wet subfloor or a block wall does not give its water up to it. The contractor seals the affected rooms and dehumidifies instead, which is the only way the readings fall in this climate, then opens the house again when the material is dry.
What does drying a hollow-tile wall involve?
Reaching the cores. Hollow tile and block do not wick like wood, but the cells fill and hold water. The contractor drills small openings at the base, pushes dry air through the cores, and reads the wall until it holds the standard. Paint and plaster outside are not a guide; the wall comes off the equipment on the reading inside.
These questions come from the Honolulu page.