After the drying
Mold Inspection & Testing in Warner Robins, GA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is the floor soft when nothing has been spilled?
Because the leak has been under the covering. Sheet vinyl is effectively sealed and runs on under the units, so water from a failed connection spreads across the subfloor without ever reaching the surface. What you feel underfoot is the panel below giving way, and by then it has usually been wet for some time.
Does the covering have to come up?
Yes, and it does not come back. The sheet is what is sealing the subfloor, so nothing dries while it is down, and lifting it destroys it. It comes up across the wet run, which normally means the whole room, because the covering was laid as one piece and there is no sensible place to stop.
What about the part under the cabinets?
That is usually the worst of it and the last to be reached. The covering runs on underneath, so the subfloor there has been wet longest with the least air, and it cannot be read or dried until the units are lifted clear. Planning for that at the start avoids finding it halfway through.
This FAQ belongs to the Warner Robins page; it is repeated here.