After the drying
Mold Inspection & Testing in Senoia, GA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What happens to an engineered subfloor panel that got wet?
It is dried and read first, and replaced only where the edges have swollen. Panel products take water at the cut edges and swell there permanently, which telegraphs through a finished floor as a ridge. If the readings come down and the edges are flat it stays. The decision is made after drying rather than on the day the water is found.
The subfloor reads wet but the rooms above feel fine. Is that a problem?
It is the normal picture for a crawl space loss and it is worth taking seriously. The living space is separated from the wet assembly by the finished floor, so nothing upstairs feels wrong while the panel and joists below hold water. Left alone that migrates upward. The readings underneath decide the job, not how the rooms feel.
The house is almost new. Does that make the job easier?
It makes it more predictable rather than easier. Recent construction means known materials, consistent framing and good access under the floor, so the drying plan is straightforward. But engineered panels and batt insulation are both less tolerant of standing water than older plank subfloors, so what gets replaced can be more, not less.
These questions come from the Senoia page.