Contained removal
Mold Removal & Remediation in Savannah, GA
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
The pro who inspects is the pro who quotes
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The crawl space was pumped but the ground is still wet. What now?
The soil is dried as part of the job rather than left to settle on its own. With a high water table, the ground under a shallow crawl space holds moisture and gives it back to the joists above for weeks. A ground cover and moving air are used to cut that off, and the framing is read until it holds before the space is closed.
Water got into the ductwork under the floor. What happens to it?
It is opened and inspected before it is run. Duct that has held water is checked by the appropriate trade, and internally lined sections that stayed wet are generally replaced rather than dried, because the lining holds moisture where nothing can reach it. Running the system first would move that moisture through the whole house.
How long is the wet season a factor here?
From roughly midsummer into early autumn, with August the heaviest at over seven inches. During that stretch the outdoor air is warm and already carries a lot of moisture, so opening a building up achieves nothing and dehumidification does the work. Jobs started in that window are scheduled with longer equipment time from the outset.
The same questions, in context, on the Savannah city page.