After the drying
Mold Inspection & Testing in Royston, GA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What should be at a roof-to-wall junction?
Metal, layered so that water always ends up on top of something that sheds it. Step flashing is woven in with the covering course by course and turned up behind the cladding, so water reaching that line runs out onto the roof. Nothing about it depends on a sealant staying intact.
Why does sealant not last there?
Because the joint moves and the material ages in ultraviolet light. Two different assemblies meet at that line and they expand and contract at different rates, so any bead spanning them is being worked constantly while it hardens in the sun. Three to five years is a realistic life.
What does the proper repair cost relative to resealing?
More at the time and far less over a decade. Putting flashing in means lifting the covering along that run and cutting the cladding back, which is a day's work rather than an hour's. Resealing is cheap each time and is usually being done for the third or fourth time by the point somebody asks.
The same questions, in context, on the Royston city page.