Contained removal
Mold Removal & Remediation in Duluth, GA
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in. The area is sealed and put under negative air, affected porous material comes out, and what remains is cleaned and treated. The assembly is then dried and read to the same standard as any water loss before it is closed, because remediation over a still-wet assembly puts the same growth back behind new drywall.
No obligation: the assessment comes before any scope
Remediation here is the tail of a water job: growth is what an unfinished drying leaves behind, and removing it without finishing the drying puts it back. The contractor establishes how far the growth extends and what moisture is still feeding it, removes what grew, and dries and reads the assembly before it is closed. The service note below covers the sequence in this city.
Often needed alongside
- Mold Inspection & Testing
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How can the wall be wet when the outside looks perfect?
Because the finish is a barrier rather than a shedding surface. A synthetic render over insulation board is close to sealed, so it looks sound however long something behind it has been wet, and there is no route for that moisture to come back out through the face. The state of the render says nothing about the state of the wall.
How is it opened up?
From the outside, in sections, and only where the readings justify it. Cutting into a sealed system means the finish has to be made good afterwards, so probes go in first to find the extent, and then the render and the board behind it come off along the wet run so the sheathing can be seen and reached directly.
What usually has to be replaced?
The sheathing more often than the framing. Timber that has been damp recovers if it is dried and still sound, but the board behind a sealed finish is typically the part that has been wet longest and has lost its strength. It is judged by hand on the material rather than by a reading.
Open the Duluth FAQ beside the housing and climate notes.