After the drying
Mold Inspection & Testing in Brunswick, GA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The pine floor has cupped since the loss. Will it flatten out again?
Often it will, if it is dried slowly and from both faces. Dense old pine cups because the underside takes up water while the top stays sealed, and forcing the top dry makes it worse. Air is moved under the joists so both faces release together, and the boards are left to settle before anyone decides what to lift. Rushing this is what turns a saveable floor into a replaced one.
Should the crawl-space vents be opened to help it dry?
Not in the warm months here. Outdoor air through the summer carries a great deal of moisture, so opening vents on a humid day brings water in rather than taking it out. The space is closed and dried with equipment instead, and the readings on the joists and subfloor decide when it is finished.
There is no cold season here. Does that matter for drying?
It matters a great deal. In a climate with a real winter, dry indoor air finishes what the equipment started. With lows near 44 degrees in January and no freezing month, that never happens, so anything closed up while still damp stays damp. Every assembly is read to the dry standard before it is shut, because nothing will correct it afterwards.
The same questions, in context, on the Brunswick city page.