Skip to content
My Water Damage and Restoration Atlanta logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Atlanta, GA

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

No obligation: the assessment comes before any scope

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
An independent contractor, walking the homeowner through what he found.

Frequently asked questions

What comes out of a finished basement after water comes through the wall?

The carpet pad always, the bottom of the drywall usually, and the carpet itself depending on how long it was wet. Water that came through a foundation wall has been through soil, so porous material it touched is treated as contaminated. The contractor removes those, dries the slab and the wall behind the framing, and the finish goes back over a dry reading.

Why is the basement taking longer to dry than the upstairs?

Because it is cooler and holds more moisture in the air and the concrete. In an Atlanta summer the basement is often the dampest space in the house before any loss, and after one the concrete gives its water up slowly. The contractor runs dehumidification below grade longer and reads the slab and the wall base rather than the room air.

Can the subfloor over a crawl space be dried without pulling the hardwood?

Often, yes, if the crawl is opened quickly. The contractor removes the wet insulation between the joists, runs air and dehumidification in the crawl space, and reads the subfloor from underneath. Hardwood above that is reached early usually survives with mats on top; hardwood that has cupped for weeks may not.

This FAQ belongs to the Atlanta page; it is repeated here.

Need mold inspection & testing in Atlanta now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415