After the drying
Mold Inspection & Testing in Pompano Beach, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Quoted on site by the contractor who visits
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
How is a leak under the floor found?
By pressure and sound rather than by sight. The line is isolated and watched for pressure loss to confirm it, then listened for along its run with equipment that picks up the escape. Warm spots on the floor from a hot line and an unexplained rise in usage both help narrow it down first.
Does the floor have to come up?
Not always. Where a single failure is located and the rest of the run is sound, the floor is opened at that point and the pipe repaired. Where the piping has begun to fail in several places, the usual answer is to abandon what is in the slab and run new lines through the attic and down the walls.
What happens to a slab that has been wet for months?
It holds the water and gives it back slowly. Concrete releases moisture upward for weeks after the leak is stopped, so anything laid back over it too soon gets trapped. The slab is metered through the joints, and the floor covering waits until the readings settle rather than until the repair is done.
Read it with the local conditions on the Pompano Beach page.