After the drying
Mold Inspection & Testing in Hollywood, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Where does the water go when a wall unit backs up?
Inward and downward, into the block. The sleeve is a hole through the wall with a pan that should drain outside, and when it blocks the water goes the other way and runs inside the masonry below the opening. It appears at the base of the wall or in the room below rather than at the unit.
Does the block around the sleeve dry out on its own?
Not really, and that is the difficulty. With no cool or dry season at any point in the year the masonry never gets a stretch where it can release what it holds, so a wall fed by a blocked pan is already carrying moisture before the loss is reported. The baseline is measured on unaffected block first.
What gets opened to deal with this?
The wall below the sleeve and whatever is finished against it. The water is inside masonry, so finishes come off the inner face along the run below the opening and the block is dried directly. The unit and its pan are dealt with as the repair, but the drying is a masonry job rather than an equipment one.
This FAQ belongs to the Hollywood page; it is repeated here.