After the drying
Mold Inspection & Testing in Gulfport, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The paint is blistering along the bottom of the wall. What does that mean?
That the block behind it is wet and has nowhere to go. A coating on both faces seals the masonry, so moisture pushes the film off rather than evaporating through it. The blistering marks where the water is, and it is a more reliable guide than a surface meter reading on a painted wall.
What has to happen before a wall like this will dry?
One face has to be opened. The inside coating is normally removed along the wet run, because it is the face that can be worked on and repainted afterward. Once the block is bare on one side, air moved across it will bring the wall down, though it takes longer than a framed wall would.
Can the same coating go back on afterwards?
That is worth a conversation before the work is finished. A film on both faces is what created the problem, so putting the identical system back invites it again. The decision belongs to whoever specifies the finish, but the wall is read and confirmed dry first, because sealing damp block is the worst possible timing.
This FAQ belongs to the Gulfport page; it is repeated here.