After the drying
Mold Inspection & Testing in Greenacres, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The wall is wet at the bottom but the pipe is higher up. Why?
Because the space it leaked into is barely an inch wide. Water fills that gap and runs straight down the face of the block to the floor, so it shows at the base whatever height the failure is at. The wall is opened along the run rather than at the damp mark, which is only where it collected.
Do the furring strips come out as well as the board?
Wherever they read high. Strips sit flat against masonry that is cool and slightly damp as a normal condition, so wood in that position takes a long time to release and a wet one holds the board against a wet wall. They are read with pins, and anything high is removed and replaced after the block is dry.
What is the run like for a wall like this in August?
Seven to ten days once it is open, and it is the block that sets the pace rather than the finish. The masonry gives its moisture up through one exposed face, the outside air offers nothing at that time of year, and the building stays closed with the equipment carrying all of it.
This FAQ belongs to the Greenacres page; it is repeated here.