After the drying
Mold Inspection & Testing in Deltona, FL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is the ice maker line such a common source?
Because of what it is made of and where it sits. Most of these were run in small plastic tubing with a push-fit or saddle connection, then pushed back against the wall behind a heavy appliance. Nothing is inspected, nothing is replaced, and the fitting spends thirty years under full pressure in the dark.
How does a small line cause a large loss?
By running unnoticed. The discharge is modest, but it is continuous and it starts under the cabinets rather than in the open. Water travels along the floor beneath the cabinet run and out into adjoining rooms, so by the time it shows at the edge of the kitchen it has been under the units for some time.
Is the ice maker line worth replacing?
Replacing the tubing with a braided line and fitting a valve you can actually reach. Both are inexpensive, and pulling the refrigerator out once every few years to look at the connection is the only inspection this part of the plumbing ever gets. It is the cheapest failure in the house to prevent.
This FAQ belongs to the Deltona page; it is repeated here.