Skip to content
My Water Damage and Restoration Wilmington logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Wilmington, DE

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

No obligation: the assessment comes before any scope

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
An independent contractor, walking the homeowner through what he found.

Frequently asked questions

What happens when the outlet blocks?

The roof becomes a tank. The parapet that holds the edge together also holds the water in, so instead of overflowing at the edge the roof ponds, and the load builds up over the ceiling of the top floor. A few inches across a rowhouse roof is a great deal of weight.

What blocks them?

Leaves and debris in autumn and ice in winter, and on older buildings the outlet itself has frequently narrowed with rust or repair material. Because the opening is through the parapet rather than in the middle of the roof, it is out of sight from below and rarely looked at.

Is an overflow worth adding?

It is one of the cheapest safeguards available on a roof like this. A second opening cut a little above the first gives the water somewhere to go when the main one blocks, and the fact that it is discharging tells anybody standing outside that something needs clearing.

The Wilmington overview carries this FAQ with the city research.

Need mold inspection & testing in Wilmington now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415