After the drying
Mold Inspection & Testing in Torrington, CT
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
The pro who inspects is the pro who quotes
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why does this basement wall read so much higher than expected?
Because of what the block is made of. Foundations of this period here were commonly laid in block made with coal ash, which is far more open than modern concrete and draws water up through itself. It will not reach the numbers a poured wall does and it is held to a stable trend instead.
Where does the spalling on the block face come from?
More likely from a previous winter. Porous block that holds water through a long freeze loses its face, and the damage shows in the spring rather than at the time. It is worth noting because it tells you the wall has been wet before, which changes how closely the framing above it is worth reading.
Should the finish go back on a wall like that?
That is worth discussing rather than assuming. Board and framing fixed tight to a wall that wicks will be wet again after the next heavy season, whatever is done now. The drying side's job is to confirm the wall is dry and to say plainly how it behaves, so the decision is made with that in hand.
The Torrington overview carries this FAQ with the city research.