After the drying
Mold Inspection & Testing in Lone Tree, CO
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why is a drip leak harder to spot than a sprinkler one?
Because nothing sprays. A broken sprinkler throws water where anyone can see it; a failed emitter simply releases under the mulch, so there is no fan of water, no wet paving and no sound. The only sign is a bed that stays darker than the others.
How much water can one actually deliver?
More than people expect, because it is the repetition rather than the rate. An emitter running freely for twenty minutes three times a week puts a steady, reliable volume into the same spot beside the foundation, week after week, all season.
How is the system checked?
By running a zone and walking it with the mulch pulled back, which nobody does until there is a problem. A pressure drop at the manifold or a zone that never seems to satisfy the controller are the early signals, and both are visible from the box.
This FAQ belongs to the Lone Tree page; it is repeated here.