Skip to content
My Water Damage and Restoration Riverside logo
A contractor arriving with a meter case and a flashlight rather than drying equipment, there to look before anything is opened.

After the drying

Mold Inspection & Testing in Riverside, CA

An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.

No obligation: the assessment comes before any scope

On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.

Often needed alongside

  • Mold Remediation

    Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.

  • Structural Drying & Dehumidification

    Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.

A homeowner at the door describing a smell that came back after a leak while the inspector listens.
An independent contractor, walking the homeowner through what he found.

Frequently asked questions

What are the recharge basins for?

Replenishing the water supply. Water is spread in large open basins and allowed to soak down into the ground, which stores it far better than a tank would. It is a sensible way to run a water system in a dry place, and it raises the level underneath.

Why is a basement wet in a year with no rain?

Because the ground water here is not rainfall-driven. When the basins are being filled, the level under the nearby neighborhoods comes up regardless of what the sky is doing, so a dry spring can be the wettest time of year below ground.

Can the schedule be found out?

It generally can, and it is worth the phone call. The operating agency knows when the basins run, and matching that against when a property goes wet settles the question quickly. It also tells a household when to expect the next one.

These questions come from the Riverside page.

Need mold inspection & testing in Riverside now?

Call (833) 243-4415
Call a Local Pro — (833) 243-4415