After the drying
Mold Inspection & Testing in Fontana, CA
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
No obligation: the assessment comes before any scope
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why do abandoned panels still matter?
Because the holes are still there. Each panel is bolted through the roof and its supply and return pipes pass through as well, and all of those were sealed when the system went in. Nobody has looked at them since it stopped working, and a bypassed system is still a set of penetrations at the top of the roof.
Is there still water in them?
Frequently yes, which is what surprises people. A system that was bypassed at the heater rather than drained still has water standing in the panels and the lines. On a roof that gets this hot, that water has been cycling between very hot and cool for decades inside pipework nobody maintains.
What should happen to one?
Removing it properly, which means draining the system, taking the panels off and making good every penetration. Leaving it is the common choice and it means a re-roof happens around the array rather than under it, which is how old mounts end up buried under a new covering.
The Fontana overview carries this FAQ with the city research.