After the drying
Mold Inspection & Testing in Phoenix, AZ
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local assessors · no obligation to proceed
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
The ceiling is wet in the middle of the room. Is the roof damaged there?
Probably not. Water under a flat coating spreads across the deck as a thin sheet and drops in wherever there is a hole in the ceiling plane, which is usually a light, a vent or a fixture. The wet spot marks a penetration, not a breach, and finding the actual failure means looking at the whole deck.
Why is the roof structure dried separately from the rooms?
Because it has a sealed top face. A coated deck cannot release upward, so all of its moisture has to come down through the ceiling. The rooms below finish in a day or two in this climate, and the deck takes a week or more. Readings are taken in the structure through openings rather than from the room.
What happens between drying and the roof being recoated?
The deck has to hold steady readings first. Coating over a deck that is still carrying water seals the moisture in permanently and the ceiling below it will come back within a season. Openings stay in place, air keeps moving through the structure, and the roofing work is scheduled on the readings rather than on the calendar.
Open the Phoenix FAQ beside the housing and climate notes.