After the drying
Mold Inspection & Testing in Dothan, AL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
What happens when a tank in a closet lets go?
All of it goes into the house. Forty or fifty gallons arrive on the closet floor with board on four sides and nothing to drain into, so it soaks the bottom of every wall around it and then runs out under the door into the rooms beyond. There is no version of this that stays in the closet.
How far does it usually reach?
Further than the closet by a considerable margin. The volume arrives at once and spreads along the floor in whatever direction the building falls, so hallways and adjoining rooms are normally involved. The extent is mapped with a meter rather than by where anything is visible.
What comes out of the closet itself?
The board around the base on all four sides, and usually more of it than elsewhere. That is where the water started and where it stood longest, and the space is small and unventilated so it dries slowest. It is often the last part of the job to be signed off.
These questions come from the Dothan page.