After the drying
Mold Inspection & Testing in Decatur, AL
An independent assessor confirms whether the assembly that got wet is actually dry, whether growth started while it was not, and how far it reaches. An inspection after a water loss confirms whether the assembly that got wet is dry now and whether growth started while it was not. Readings are taken in the material, cavities are opened where the readings point, and the result is a written scope of what is dry, what is not, and what has to be corrected for the repair to hold.
Independent local crews · scoped at the property
On this site, inspection is the last check of a water job rather than the start of a separate one. Most people reach this page because something was wet, was dried, and a smell or a stain came back. The inspection answers whether the material is dry now and whether anything grew while it was not. Nothing here is medical advice; questions about health are for a clinician.
Often needed alongside
- Mold Remediation
Growth and the material it grew into come out under containment, what remains is cleaned, and the assembly is dried and read before anything closes it in.
- Structural Drying & Dehumidification
Sealed air movers and dehumidifiers bring framing, subfloor and drywall back to a measured dry standard, with daily readings logged from inside the material.
Frequently asked questions
Why does the flooring in this room keep failing?
Because of what is under the slab rather than what is on it. A carport floor was poured to be parked on, without the barrier that goes under a living floor, so it takes moisture from the ground continuously and passes it to anything bonded on top. Very often the covering has been releasing long before any loss occurred.
Does that change what can be put back?
It does, and it is worth settling early. Bonding a new covering onto a slab that is feeding moisture from below will fail the same way, so either the slab is treated first or a covering that tolerates it is chosen. The drying and the decision about the floor are two separate conversations.
How is the slab read when it is always damp?
Against itself rather than against a target. An unaffected part of the same slab is measured to establish what normal looks like for it, and the affected area is dried back to that. Waiting for a figure that a floor like this has never reached would keep the job open indefinitely.
This FAQ belongs to the Decatur page; it is repeated here.